Transit PCM Configuration incompatible

Resolving problems with software and hardware

Transit PCM Configuration incompatible

Сообщение md86 » 28 янв 2019, 13:21

Не в сети
md86
Сообщения: 3
Зарегистрирован: 25 янв 2019, 22:34
Благодарил (а): 0 раз. Поблагодарили: 0 раз.
Hello,
I need to change PCM configuration in Transit Custom 2016 2,2TDCI (SID208)
PCM was repleaced because original is dead (mainboard is broken)
I updated soft by IDS writting VIN of the car but I still have DTC U2101:86 (configuration incompatible)
Could you help to resolve this problem?
Не в сети
md86
Сообщения: 3
Зарегистрирован: 25 янв 2019, 22:34
Благодарил (а): 0 раз. Поблагодарили: 0 раз.
To additional clarify the problem.
Installed ECU is from car which had Start/Stop system.
This car doesn't has this system and probably this is reason of configuration error.
In my opinion solution is writing soft without START/STOP system or another way to change configuration.
Thank you for any sugestions.
Не в сети
gregd72002
Сообщения: 2
Зарегистрирован: 12 фев 2019, 19:09
Благодарил (а): 0 раз. Поблагодарили: 0 раз.
PATS information is stored in BCM and PCM in Transits. If you replace PCM you need to reinitialise PATS and sync the module.
Не в сети
md86
Сообщения: 3
Зарегистрирован: 25 янв 2019, 22:34
Благодарил (а): 0 раз. Поблагодарили: 0 раз.
PATS is not topic of this post!
The ECU was reinitialised and synchro is done.
Engine is working but there is problem with INCOMPATIBLE CONFIGURATION in PCM!
Engine error is still active on the dash.

Вернуться в Technical Support

Кто сейчас на конференции

Сейчас этот форум просматривают: Bing [Bot] и гости: 1