Mondeo MK5 TCM update P0949 error code after

Resolving problems with software and hardware
Не в сети
saittoku
Сообщения: 2
Зарегистрирован: 11 май 2019, 19:29
Благодарил (а): 0 раз. Поблагодарили: 0 раз.
Hello,

i just updated powersift TCM module via UCDS and that not was succesful. There was U2100...not completed trouble code. I flashed TCM back to original and there was same problem. I updated TCM after that via ford etis and it was succesfully.

After making learnings to clutch and sifter powersift, there was came malfunction code "P0949 Auto Shift Manual Adaptive Learning Not done". I tried many times but always same happen.

How i can return or fix that problem?

My vin is WF0EXXWPCEFC58527

Thank you in advance

-S-
Не в сети
mazolla
Сообщения: 7
Зарегистрирован: 10 мар 2017, 23:38
Благодарил (а): 0 раз. Поблагодарили: 0 раз.
Hy
Make Learning over ETIS Online (FDRS).
Since last Softwareupdate UCDS don't work well for this job.
I try it few times and allways get errors on.
I fix it over Etis Online (FDRS)
Не в сети
saittoku
Сообщения: 2
Зарегистрирован: 11 май 2019, 19:29
Благодарил (а): 0 раз. Поблагодарили: 0 раз.
I tried that, but not success. Then I delivered car to Ford original repairing shop and there was same problem. There is new trouble code as well, p2849 shift fork a stuck....
They will change the mechatronics to new one. Is that needed really I don't know.

Вернуться в Technical Support

Кто сейчас на конференции

Сейчас этот форум просматривают: dragunov и гости: 2